Abstract from pre-fault conditions. Mathematical morphology based time

Topic: EntertainmentGames
Sample donated:
Last updated: March 19, 2019

Abstract – This paper proposes an intelligent method to detect High Impedance Fault (HIF) in distribution networks using Wavelet Transform (WT) and data mining based Decision Tree (DT) model.

The proposed method uses WT to decompose the current signal and extracts significant features of the signal. The data mining model reduces the features of the signal and also frames a DT model for the classification of HIF and non-HIF cases. The current signal data for HIF and non-HIF events (Capacitance switching, Linear and Non-Linear load switching) have been acquired by an accurate model of an actual distribution system using MATLAB / SIMULINK. The simulation results show that the proposed method can provide a consistent and powerful protection for HIF.

Don't use plagiarized sources.
Get Your Custom Essay on "Abstract from pre-fault conditions. Mathematical morphology based time..."
For You For Only $13.90/page!

Get custom paper

 Index Terms -High impedance fault, Wavelet transform, Data mining, Decision tree, Non-linear load. I.  Introduction              The electric power distribution system is usually overhead lines. These are more vulnerable to breakdown of power supply due to the fact that is exposed to dissimilar climatic circumstances. Some of these failures may be detected and located easily. However, there are few failures which cannot be detected by conventional protective means. For example, when an energized broken or unbroken line connected to high impedance objects or surfaces draws the least amount of current 1 with no evidence of defect, such kind of fault classified as High Impedance Faults (HIFs). If The distribution system running with unidentified HIF for hours or days leads to damaging the equipment connected to the supply.

Moreover, from the investigation, it is observed that the electric arcs turn out an arbitrary, erratic and asymmetric current followed by HIF 2. The distribution systems are close to populated areas, where the electrical arcs lead to fatal for the public. Detection of HIFs are matter of interests from early 1970, nevertheless the enlightening on detection process yet to be completed. A method based on the lower order harmonic ratio presented in 3.

The drawback of such kind of methods needs to set few threshold values which is affecting the performance of detection method. Time-frequency analysis based methods 4-5 exposed good performance in the detection process. However, the percentage of false detection is shown as a major setback for practical applications.Time domain approaches use to detect the change in current or voltage signal from pre-fault conditions. Mathematical morphology based time domain methods found in 6-8, which is an effective detection method in a balanced system, there are few issues associated with unbalanced network.Wavelet Transform (WT) has been extensively used in signal processing because of its capability to detect the frequency component and their position in time. More than a decade such methods applied to power system protection. Although WT based methods are providing good detection rate with linear loads 9-13, no evidence of non-linear loads inclusion with the systems while detecting HIFs except  in 14.

The existence of non-linear loads (NLLs) in the system has continuously increased right through the power distribution grids. Whereas huge quantities of existing methods have failed to consider NLLs while modelling and designing of practical HIF detection methods. The NLLs and HIFs characteristics have closely resembled each other, which will make the existing methods less effective. Hence, In this paper, an enhanced method for detection of HIFs including huge variation of NLLs is Proposed.

            The rest of the paper has been prepared as follows. Section II explains the test system and also the characteristics of HIF model engaged for simulation. The process of proposed methodology has been thoroughly discussed in Section III, including the decomposition of a signal, feature extraction, feature selection and classification.

Section IV has results and discussion and the paper concluded with the main highlights of the work in section V. II. TEST SYSTEM A. System Studied              The effectiveness of the proposed method is demonstrated on an accurate model of an actual power system in India (Chennai) shown in Fig.

1 was modelled by a SimPowerSystem blockset of MATLAB. The system and load data are given in Table 1. Distribution lines are modelled with lumped parameters. B.  HIF Model and CharacteristicsThe model of HIF is equally important to attain consistent simulation results and design a detection method. Various HIF models have been proposed for the reason of simulation and studying the nature of the fault.

For the sake of simplicity, the HIF model employed in this paper based on Emanuel’s model 3 shown in Fig. 2. The HIF current waveform observed for various parameters of the model is

Choose your subject


I'm Jessica!

Don't know how to start your paper? Worry no more! Get professional writing assistance from me.

Click here